HIKVISION AE-MD5043 - Camera Management; Configure Encoding Parameters

Mobile Video Recorder User Manual
27
Chapter 7 Camera Management
Configure Encoding Parameters
Configure encoding parameters to adjust live view image and video parameters.
Go to Configuration > Video/Audio > Video.
In good network situation, you can set high resolution and bitrate to improve image quality.
In bad network situation, you can set low resolution, bitrate, and frame rate to get fluent image.
 In good network situation, you can set high resolution and bitrate to improve image quality.
 In bad network situation, you can set low resolution, bitrate, and frame rate to get fluent
image.
 In bad network situation, if you want to guarantee the resolution, you can set low bitrate and
frame rate to get fluent image.
Encoding Parameters
Options
Descriptions
Stream Type
Main Stream is used for HD storage and live view. Sub Stream is used
for BD storage and live view when the network bandwidth is
insufficient.
Video Type
If you want to record both video and audio, select Video&Audio. If you
just want to record video, select Video Stream.
Resolution
The higher the resolution, the clearer the image, and the higher the
requirement of network bandwidth.
Bitrate Type
You can select Variable or Constant.
Video Quality
If the bitrate is variable, you can select video quality according to your
needs. The higher the video quality, the higher the requirement of
network bandwidth.
Frame Rate
The higher the frame rate, the higher the requirement of network
bandwidth, and the higher the needed storage capacity.
Max. Bitrate
If the bitrate is variable, enter the max. bitrate. The bitrate will change
automatically below the max. value.
Video Encoding
Select H.265 (only supported by some models) or H.264 according to
the actual needs.
Configure Audio Parameters
You can configure the audio encoding format.