Mobile Video Recorder User Manual
35
Configure Video Loss Alarm
When the recorder cannot receive video signal from the analog cameras, the video loss alarm will
be triggered. Linkage actions, including audible warning and alarm output, can be set to respond.
Go to Configuration > Event > Basic Event > Video Loss.
Check Enable Video Loss Detection.
Configure arming schedule. For detailed steps, refer to Configure Arming Schedule.
Configure linkage method. For detailed steps, refer to Configure Linkage Actions.
Click Save.
Configure Alarm Input
Configure the settings for alarm input, including trigger level, arming schedule and alarm linkage
actions, etc.
Before You Start
Connect an alarm device to your recorder.
Go to Configuration > Event > Basic Event > Alarm Input.
Configure Alarm Input
Select Alarm Input No. and enter Alarm Name.
Select Alarm Type according to alarm device type.
To Next Page
Loading...
