4.3 Marking Waveforms and Searching Marks (Search Function)
93
3
Chapter 4 Observing Measurements and Data
4
You can insert up to 100 event marks at any point while measuring,
to help find them later.
See: "Searching Event Marks" (p. 97)
Event marks can be applied by the following methods.
Press START while measuring
Press the on-screen [Make Mark] button.
Apply a signal to the EXT TRIG terminal
When a warning occurs
Use this procedure to insert event marks while viewing data on the Waveform/Numerical
Value screen during measurement.
Press START to apply a mark.
Event marks are numbered in the sequence they are inserted.
Marks can also be applied with the following procedures.
4.3 Marking Waveforms and Searching Marks
(Search Function)
Inserting Event Marks While Viewing Waveforms
Select [Event].
1
The event settings are displayed.
3
Apply
Select [Gauge+Wave].
Move to [Make Mark].
Press to insert an event
mark.
Event numbers appear on the
waveform displayed when you
select [Make Mark].
2
Select [Channel].
2
3
To Next Page
Loading...
