Hioki LR8402-20 - Appendix 6 List of Default Settings

Appendix 6 List of Default Settings
A11
Appendix
When shipped from the factory or initialized to factory defaults, the settings are as
follows.
Appendix 6 List of Default Settings
Screen Setting Item Default Setting
Setting Interval 20ms
(50 ms when initial-
ized with expansion
input units installed)
Filter 60Hz
Time/DIV 100ms/DIV
Cont On
Repeat Off
Numerical
Calc.
Off
Calc1,2,3,4,5,6 Off
Timer Off
Auto Save Off
CH On/Off On for UNIT1-1 to 2-
15 only
(Expansion unit chan-
nels are also On when
initialized with the
unit(s) installed.)
Input Voltage
Range 10mV
Thermocouple K
Burn Out Off
RJC Int
Count Mo Add
Pulse/Rev 1
Slope 
Disp Span Pos
Zoom Voltage/Revolve:×1,
Tc: ×1
0 Pos Voltage: 50%,
Tc/Revolve: 0%
Upper Voltage: 0.005,
Tc: 100,
Count/Revolve: 5000
Lower Voltage: -0.005,
Tc/Count/Revolve: 0
Scaling Off
Start Trig. Off
Stop Trig. Off
Alarm1, 2, 3, 4 Off
Trig &
Alm
Trig Func Off
Timing Start
Trig Source
Start OR
Stop OR
Ext trig
Start Off
Stop Off
Pre-Trig 0d 0h 0m 0s
Alarm Source Off
ALM1, 2, 3, 4 OR
System Start Backup Off
File Protection Low
Backlight saver OFF
Backlight
Brightness
100%
Display Color Black
Beep Sound ON
Time Disp Time
Language English
External Trig In Trigger
Starg/Stop
message
ON
Decimal Mark Dot
Separator Comma
N-Calc. Data
Saving
Single file
Event mark for
alarm
OFF
SAVE Key Op-
eration
Select & Save
Screen Setting Item Default Setting