8.2 Screen Key Operation Settings
153
3
Chapter 8 System Environment Settings
8
If power is lost within about three minutes after power-on, files on the removable storage
may be corrupted, and the device could be damaged. These risks can be avoided by set-
ting the file protection level to [High].
File Protection
A backlight saver can be activated after a specified number of minutes during which no
ope
ration key is pressed. The backlight saver turns off the backlight of the LCD, prolong-
ing the lifetime of the backlight by turning it off when not needed.
To deactivate the backlight saver, press any key. The operating screen appears
again.
Backlight
Save
r
• Be aware that power is still consumed even when the backlight is off,
so be su
re to turn the HiLogger power switch off when not in use.
• While the backlight saver is active, the HiLogger's measuring state is
still indicated by the LED.
File Protection Level Setting
Setting options:( : default setting)
Low
Although removable storage is recognized and
ready for recording immediately upon power-on,
if power is lost within about three minutes after
power-on, files on the removable storage may
be corrupted, and the device could be dam-
aged.
High Removable storage is not recognized for three
minutes after power-on (when data could be
corrupted or the device damaged).
Auto-Setup is not available when [High] is selected (p. 132).
8.2 Screen Key Operation Settings
Enabling and Disabling the Backlight Saver
Setting options:( : default setting)
Off
Disables the backlight saver function.
The operating screen is always displayed.
1 min, 2
min, 3 min,
4 min, 5 min
The backlight saver is activated if the spec-
ified time is exceeded.
To Next Page
Loading...
