Hioki LR8402-20 - Apply Calculations to a Specific Time Span (Manual Calculation Only)

7.1 Calculate Average, Maximum, Minimum, and Etc.
147
3
Chapter 7 Numerical Calculations/Waveform Calculations
7
After measuring, calculation can be applied to a specified time span.
Make any other calculation settings before specifying the calculation time span (P.146 , 1
to 5).
Apply Calculations to a Specific Time Span (Manual Calculation
Only)
1
4
Press the left/right SCROLL/CUR-
SOR keys to move the A/B cursors
to specify the time span.
See: Changing the cursor to move (p. 90)
Move to a [Span] item.
3
Apply
Open the setting options
for the item to be set.
Select [Sw to Calc].
Apply
5
Select [Exec].
Apply
The results of calculations are
displayed.
Press SCROLL/CURSOR to display
A/B cursors.
4
5
Select the calculation time
span.
See the table at the right for set-
ting choices
Setting options: (
 : default setting)
All*
The entire acquired waveform
A-B
The time span between cursors
A and B
Start-A
From the start of the acquired
waveform to cursor A
Start-B
From the start of the acquired
waveform to cursor B
A-End
From cursor A to the end of the
acquired waveform
B-End
From cursor B to the end of the
acquired waveform
2
1
2