3.5 Waveform Display Settings (as needed)
66
The vertical display range and zero position can be specified for each channel.
The magnification setting determines the displayed range. Waveforms are expanded or
compressed vertically relative to the center of the screen.
Make these settings on the [CH] scr
een.
See: "Key Setting Procedure" (p .65)
Specifying Vertical Display Range by Magnification and Zero Position
(vertical axis expansion/compression)
Zero Position: 50%
25%
0 V
100%
0%
50%
0 V
25%
Normal Display
Magnified
Display (x2)
The display range of the vertical axis
emphasizing 0V display position
Display range magnification setting
(expansion/compression)
1 Select [Pos].
2 Select the magnification.
3 Set the desired zero position as a percentage
of screen height.
Setting options:( : default setting)
x100, x50, x20, x10, x5, x2, x1
, x1/2
Setting options:
-50 to 150% (with x1 magnification)
Zoom Zero-Position
setting range
Zoom Zero-Position
setting range
x1/2 0 to 100% x10 -950 to 1050%
x1 -50 to 150% x20 -1950 to 2050%
x2 -150 to 250% x50 -4950 to 5050%
x5 -450 to 550% x100 -9950 to 10050%
1
2
3
Default Setting
Input type Zoom Zero position Input type Zoom Zero position
Voltage x1 50
Resistance (Resist) x1 0
Temperature (Tc) x1 0 Logic
Temperature (Rtd) x1 0 Integration (Count)
Humidity (Humid) x1 0 Revolution (Revolve) x1 0
Change 1's digit
The expansion/com-
pression range de-
pends on the selected
magnification.
50%
100%
(Zoom: x1)
Measurement range
Display range
0%
50%
100%
50%
100%
0%
0%
100%
50%
0V
Zero position:
0%
Magnification and zero-position settings are ignored when the display
range is defined by upper and lower limits.
To Next Page
Loading...
