6.5 Transferring Data to a PC (USB Drive Mode)
141
3
Chapter 6 Saving & Loading Data
6
Compatible OS: Windows XP, Vista, or 7
To exit USB Drive Mode
Connecting the USB Cable
• Do not eject the CF card or pull out the USB cable during data transfer.
Doing so would prevent proper data transfer.
• The HiLogger and PC should be connected to the same earth ground. If
grou
nded separately, potential difference between the ground points can
cause malfunctions or damage when connecting the USB cable.
Orient the USB cable
plug properly, and insert
it into the receptacle.
1
Connect the other end of the
cable to a USB port on the PC.
The PC should recognize the HiLog-
ger as a removable disk when the
cable is connected.
2
Removable
Disk
Before connecting the USB cable to the HiLogger, select the USB Drive Mode
on the [System] screen. Otherwise, the HiLogger's CF card cannot be accessed.
1 Click the Safely Remove Hardware ( )
icon in the Windows notification area.
2 Click the appropriate line “Safely remove
USB Mass Storage Device? Drive(H:)”
where H is the drive letter that Windows
assigned to the HiLogger.
3 When “Safe to remove hardware” appears,
click [X] or [OK].
4 Disconnect the USB cable.
5
Turn the HiLogger off and back on.
To Next Page
Loading...
