3.3 Input Channel Settings
59
3
3
Chapter 3 Settings
Enable this channel setting for humidity measurement with the optional Z2000 Humidity
Sensor. Make these settings on the [CH] screen.
See: "Key Setting Procedure" (p .53)
Humidity Measurement Settings
1 Select the input unit (UNIT1 to 4) and channel
(1-1 to 4-15), and check the box to enable the
channel.
2 Select [Humid].
1
* The range is fixed at [100% f.s.].
2*
: On
: Off
When a measured value far exceeds the range limit (range label)
"OVER" or "-OVER" is displayed in place of numerical/cursor values, and the following values
are applied to calculations and data storage.
Input type Input range +OVER value -OVER value
Humidity 100%RH 3276.7 -3276.8
To Next Page
Loading...
