Hioki LR8402-20 - Enable the Trigger Function; Key Setting Procedure

5.1 Triggering Measurement Start and Stop
101
3
5
Chapter 5 Specifying Criteria for Measurements
Before setting trigger criteria, trigger functions need to be validated.
Enable the Trigger Function
Enable the Trigger Function
1. Select the trigger to use, and
press ENTER.
Put the cursor on [Start trig on.] for a start
trigger, or on [Stop trig on.] for a stop trigger,
and press ENTER.
2. Press it again when the confirma-
tion message appears.
[Cond:Off] appears, and trigger criteria set-
tings are enabled.
When [Cont:] is displayed, triggering is en-
abled (On).
To disable triggering, set [Trig Func:Off] on
the [Trig & Alm] screen.
Set trigger criteria
Select the trigger criteria to be applied.
See: P.102 to P.104
Triggering can be enabled/disabled (On/Off)
and criteria selections can be set on the [Trig
& Alm] screen.(p. 114)
The [Timming] setting on the [Trig & Alm] screen deter-
mines the effect of triggering, as follows:
• Start recording upon trigger: [Start]
• Stop recording upon trigger: [Stop]
• Alternately start and stop upon trigger: [Start/Stop]
Measuring
T T T T
Start
Stop Start / Stop
Key Setting Procedure
Move to a setting item.
Apply
Open the setting options
for the item to be set.
Select from the listed
options.
1
2
Select the [CH] or 
[Trig & Alm] Screen.