1 Start and finish measuring.
2 Select the [Wave+Calc] display on the Wave/Numerical screen.
3 Select [On].
4 Select any of [Calc1] to [Calc6]. (Default setting: [Calc1])
5 Select the calculation type.
6 Select [Exec], and execute.
Numerical calculation results are displayed.
Setting options: (
: default setting)
Average, P-P, Maximum, Minimum, T
ime to Max, Time to Min, Off
The results of
the selected
calculation
(Calc no.) are
displayed.
The results of the se-
lected input unit are dis-
played. Press UNIT to
switch the display to
another input unit.
6
3
2
4
5 6
Make these settings on the [Setting] screen.
After setting, select [Wave+Calc] display on the Wave/Numerical screen, and select [Exec]
to execute calculations.
Select Execute
To Next Page
Loading...
