Hioki LR8402-20 - 3.5 Waveform Display Settings (as needed)

3.3 Input Channel Settings
53
3
3
Chapter 3 Settings
Configure the input channel settings on the [CH] screen.
Input channels are as follows. Each channel can provide the following measurements.
•Voltage/Temp Unit (UNIT1 to UNIT4, each with analog waveform input channels CH1 to
CH15)
•Universal Unit
(UNIT1 to UNIT4, each with analog waveform input channels CH1 to
CH15)
•The HiLogger's external control terminals (pulse/logic waveform inputs P1 to P8)
Other than these, measurements with specific criteria and alarm outputs are available.
See "
Chapter 5 Specifying Criteria for Measurements" (p. 99) for details.
3.3 Input Channel Settings
The Setting screen cannot be displayed while measuring.
Application Channels Used
Reference
page
Voltage Measurement
Channels on a Voltage/Temp
Unit or Universal Unit
(p. 55)
Temperature Measurement (using thermocouples)
(p. 56)
Humidity Measurement (p. 59)
Humidity Measurement (using RTDs)
Channels on an Universal Unit
(p. 58)
Resistance Measurement (p. 60)
Pulse or Logic Measurement
Pulse/logic input channels
(Hi
Logger external control ter-
minals)
(p. 61)
Integration (Count) Measurement (p. 62)
Revolution Measurement (p. 63)
Key Setting Procedure
Select the [CH] screen.
Move to a setting item.
Apply
Open the setting options
for the item to be set.
Select from the listed op-
tions.
1
2
UNIT selects the input unit and CHAN select
the channel to be set.