Hioki LR8402-20 - Page 157

7.1 Calculate Average, Maximum, Minimum, and Etc.
145
3
Chapter 7 Numerical Calculations/Waveform Calculations
7
4
When set to Ref
Time.
3 Configure Auto Save.
Select [[Calc(post meas.)], [Waveform + Calc], or [CSV + Calc].
When [W
aveform(realtime)] or [CSV(realtime)] is selected, the settings in step 4 are
not available.
4 Select a split-calculation (timing) method.
5 Start measuring.
6 Select [Wave+Calc] display on the Wave/Numerical screen.
Numerical calculation results are displayed.
Setting options: (
 : default setting)
Off

Save only the last calculation results.
On Save calculation results at a fixed interval. Set the calculation interval
equal to the [Length].
Ref Time Save calculation results at a fixed interval. Set the calculation time to the
[Split time] and [Split Length].
3
4
When set to On.
The results of
the selected
calculation (no.)
are displayed.
The results of the select-
ed input unit are dis-
played. Press UNIT to
switch the display to an-
other input unit.
6
Select whether to display
calculations from the start of
measurement (normal), or
the latest calculations after
each interval (split value).
When split calculation is dis-
abled, the split value is dis-
played as "- - -".