Hioki LR8402-20 - 9.2 External Signal Output (Trigger Output)

7.3 Waveform Calculations
150
The calculation formula can be entered on the [Conv/Calc] screen.
The calculation formula entered for channel W1 can be copied to other channels (p.
74)
.
1 Select [CALC1] or [CALC2] and channel W1 to
W30, then select the check box ([ ]) to
enable
calculation.
2 Set the [calculation formula], and press
ENTER.
The coefficient setting dialog is displayed.
3 Enter or select coefficient a, CH A, coefficient
b, CH B, coefficient c, and the measurement
units, and press ENTER.
1
2
Increment/decrement by
1, change sign (+/-)
Select setting field
: On
: Off
Coefficient setting dialog
See: "Numerical Value Entry" (p .67)
3
1 Select the [Conv/Calc] Screen.
2 Move the cursor to [Calc 1] or [Calc 2].
3 Select channel W1 to W30.
The coefficient setting dialog is displayed.
4 Enter or select coefficient a, CH A, coefficient
b, CH B, coefficient c, and the measurement
units, and press ENTER.
Increment/decrement by
1, change sign (+/-)
Select setting field
Coefficient setting dialog
2
3
4