1.2 Measurement Flow
15
3
1
Chapter 1 Overview
Select input channels, and set input
types and measurement ranges.
Pre-existing setting configuration data can be loaded from the HiLogger or removable stor-
age (p. 132).
Make other settings as needed.
Waveform Display (p. 65)
Scaling (p. 69)
Titles and Comments (p. 71)
Noise Suppression (p. 73)
View/Edit All-Channel Settings List
(p. 74)
Move to a
setting
Open the
setting
Select Apply
Configure Input Channels (p. 53)
Press the START / STOP
Measure (Record) once, and stop.
[Repeat]: Off
Stop
Measure-
ment
When measuring (recording) using the trigger function (p. 99), measuring occurs only
when an input waveform satisfies the specified trigger criteria.
(default setting)
Measure (Record) repeatedly.
[Repeat]: On
3. Starting and Stopping Measurement (p. 23)
Start Measurement
4. Observing Data
View Measurement Data (p. 83)
Waveforms can be zoomed and numeri-
cal values confirmed.
Save Data (p. 121)
Measurement data, waveform data,
screen images and numerical calcula-
tion results can be saved.
Calculate (p. 143)
Numerical measurement data can be ap-
plied to calculations.
View on a PC (p. 187)
Observe measurement data with the
supplied Logger Utility program.
5. When Finished
Turn the HiLogger Off (p. 44)
To Next Page
Loading...
