About this Manual
10
Basic - L3P
Release
3.1
06/07
You will find detailed descriptions of how to operate the individual functions in
the “Web-based Interface” and “Command Line Interface” reference manuals.
If you use Network Management Software HiVision you have further
opportunities to:
D have an event logbook.
D configure the „System Location“ and „System Name“.
D configure the network address range and SNMP parameters.
D save the configuration on the Switch.
D simultaneous configuration of several Switches.
D configure the relevant ports to be displayed red if there is no link state.
To Next Page
Loading...
Need help?
General
