Hirschmann Power MICE - SNMP Traps When Booting; Configuring Traps

Operation Diagnostics
168
9.1 Sending traps
Basic - L3P
Release 3.1 06/07
9.1.2 SNMP traps when booting
The ColdStart trap is sent during every boot procedure.
9.1.3 Configuring traps
V Select the Diagnostics:Alarms (Traps) dialog.
This dialog allows you to specify which events trigger an alarm (trap) and
to whom these alarms should be sent.
V In the “IP Address” column, enter the IP address of a network
management station to which the traps should be sent.
V In the “Active” column, you mark the entries which should be taken
into account when traps are being sent.
V In the frame “Selection” select these trap catagories from which you
want to send traps
Note: Access this dialog with read-write password.