Entering the IP parameters
Basic - L3P
Release
3.1
06/07
2.9
Faulty Device Replacement
49
2.9 Faulty Device Replacement
There are two plug-and-play solutions available for replacing a faulty Switch
with a Switch of the same type
(Faulty Device Replacement):
D First, you can configure the new switch using an AutoConfiguration
Adapter
(see “Loading the system configuration from the ACA” on page 37) or
D Second, you can configure the new switch using DHCP Option 82
(see “System Configuration via DHCP Option 82” on page 46).
In both cases, the same configuration data which the faulty Switch had are
transferred to the new Switch during booting.
To Next Page
Loading...
