Entering the IP parameters
Basic - L3P
Release
3.1
06/07
2.4
Loading the system configuration from the
37
2.4 Loading the system
configuration from the ACA
The ACA is a device for
D storing the configuration data of a Switch.
D storing the Switch software.
In the case of a Switch failure, the ACA enables a very simple configuration
data transfer by means of a substitute Switch of the same type.
When you start the switch, it checks for an ACA. If it detects an ACA with a
valid password and valid software, the Switch loads the configuration data
from the ACA.
The password is valid if
D the password on the Switch matches the password on the ACA, or
D the preset password is entered on the Switch.
To save the configuration data in the ACA see “Saving Locally (and on the
ACA)” on page 57
To Next Page
Loading...
