About this Manual
Basic - L3P
Release
3.1
06/07
9
About this Manual
The “Basic Configuration” user manual contains all the information you need
to start operating the switch. It takes you step by step from the first startup
operation through to the basic settings for operation in your environment.
The following thematic sequence has proven itself in practice:
D Set up device access for operation by entering the IP parameters
D Check the status of the software and update it if necessary
D Load/Save the configuration
D Configure the ports
D Set up protection from unauthorized access
D Optimize the data transmission with network load control
D Synchronize system time in the network
D Function diagnosis
The “Installation” user manual contains a device description, safety instructions,
a description of the display, and all the other information that you need to install
the device before you begin with the configuration of the device.
The “Redundancy Configuration” user manual contains all the information
you need to select a suitable redundancy procedure and configure it.
The “Industrial Protocols” user manual describes how the Switch is
connected by means of a communication protocol commonly used in the
industry, such as EtherNet/IP or PROFINET.
The “Routing Configuration” user manual contains all the information you
need to start operating the routing function. It takes you step by step from
a
small router application through to the router configuration of a complex
network.
The manual enables you to configure your router by following the examples.
To Next Page
Loading...
Need help?
General
