Hirschmann Power MICE - Starting the Software; Performing a Cold Start

Loading Software Updates
Basic - L3P
Release 3.1 06/07
4.1 Loading the Software from the ACA
65
U Test stored images in USB memory
Select 4 to test, if the stored images of the software in ACA 21-USB con-
tain valid codes.
U Apply and store selection
Select 5 to apply and store the selection of the software.
U Cancel selection
Select Sie 6 to cancel selection and leave this dialogue without changes.
4.1.2 Starting the software
This menu of the System monitor offers you the possibility to start the selec-
ted software.
4.1.3 Performing a cold start
This menu of the system monitor offers you the possibility to reset the hard-
ware of the Switch and to reboot.