Loading/saving settings
52
3.1
Loading settings
Basic - L3P
Release
3.1
06/07
3.1 Loading settings
During restart, the Switch automatically loads its configuration data from the
local non-volatile memory, provided that you have not activated BOOTP/
DHCP and that no ACA is connected to the Switch.
During operation, the Switch enables you to load settings from the following
sources:
D the local non-volatile memory,
D the AutoConfiguration Adapter. If an ACA is connected to the Switch, the
Switch always loads its configuration from the ACA.
D a file in the connected network (= state on delivery)
D a binary file or an editable and readable script on the PC and
D the state on delivery.
Note: When loading a configuration, do not access the Switch until it has
loaded the configuration file and has made the new configuration settings.
Depending on the complexity of the configuration settings, this procedure
can last between 10-200 seconds.
To Next Page
Loading...
Need help?
General
