Setting up the configuration environment
216
A.4
Preparing for access via SSH
Basic - L3P
Release
3.1
06/07
PuTTY will display another security alert message for the set warning threshold.
Fig. 82: Security alert prompt for the set warning threshold
V Click “Yes” to this security alert message.
To suppress this message for future connection setups, select “SSH” in
the
“Category” frame before you set up a connection in PuTTY. In the
“Encryption options” frame, select “DES” and then click “Up” until “Des”
is
above the line “---warn below here --". In the “Category” frame, go back to
Session and set up a connection as usual.
The OpenSSH Suite offers experienced network administrators a further
option of accessing your Switch via SSH. To set up the connection, enter the
following command:
ssh admin@149.218.112.53 -cdes
admin represents the user name.
149.218.112.53 is the IP address of your Switch.
-cdes specifies the encryption for SSHv1.
To Next Page
Loading...
