Entering the IP parameters
40
2.5
System configuration via BOOTP
Basic - L3P
Release
3.1
06/07
switch_01:ht=ether
net:ha=008063086501:ip=149.218.17.83:tc=.global:
switch_02:ht=ether
net:ha=008063086502:ip=149.218.17.84:tc=.global:
.
.
Lines that start with a '#' character are comment lines.
The lines under “.global:” make the configuration of several devices easier.
With the template (tc) you allocate the global configuration data (tc=.global:).
The direct allocation of hardware address and IP address occurs in the de-
vice lines (switch-0...).
V Enter one line for each device.
V After ha= enter the hardware address of the device.
V After ip= enter the IP address of the device.
Refer to “Setting up DHCP/BOOTP Server” on page 196) for a BOOTP/
DHCP server configuration example.
To Next Page
Loading...
