Copyright © 2019, 2021, Hitachi, Ltd.
DKC910IHitachi Proprietary
[INST(IN)05-01-10]
Rev.0
INST(IN)05-01-10
5. Removing Components
1. Work Procedure before Installing the Rack Mounting
When installing the rack by the special lifter, install it in the rack frame with each part installed. (Work
on “6. Mounting on a Rack Frame”.)
When installing the parts, hold it in the way that ngertips of the hand putting the wrist strap on touches
the metallic portion of the side.
NOTICE:
• To prevent part failures caused by static electrical charge built up on your own
body, be sure to wear a wrist strap connected to the Storage System before starting
and do not take it o until you nish. Refer to “Note when Installing and Removing
Parts” (INST(GE)01-01-10).
• Be sure to wear a wrist strap connected to the Storage System whenever you
unpack parts from a case. Otherwise, the static electrical charge on your body may
damage the parts.
To Next Page
Loading...
