Hitachi DKC910I - Installing Components

Copyright © 2019, 2021, Hitachi, Ltd.
DKC910IHitachi Proprietary
[INST(IN)08-01-10]
Rev.0
INST(IN)08-01-10
8. Installing Components
When the components are not installed, install them.
When installed, this work is not necessary. Go to the next step.
When installing the parts, hold it in the way that ngertips of the hand putting the wrist strap on touches the
metallic portion of the side.
NOTICE:
• To prevent part failures caused by static electrical charge built up on your own
body, be sure to wear a wrist strap connected to the Storage System before starting
and do not take it o󰀨 until you nish. Refer to “Note when Installing and Removing
Parts” (INST(GE)01-01-10).
• Be sure to wear a wrist strap connected to the Storage System whenever you
unpack parts from a case. Otherwise, the static electrical charge on your body may
damage the parts.