Copyright © 2019, 2021, Hitachi, Ltd.
DKC910IHitachi Proprietary
[INST(IN)09-04-10]
Rev.1
INST(IN)09-04-10
9.4 Connecting SAS Cables/NVMe Cables
Connect a Controller Chassis and a Drive Box or a Drive Box and another Drive Box with the SAS cable or
the NVMe cable.
9.4.1 Precautions when Connecting SAS Cables/NVMe Cables
NOTE : • The rubber cap is attached to the SAS connector.
Remove the rubber cap before installing the SAS cable.
• The plugs of the SAS cable have no distinction between IN and OUT. They can be
inserted in both IN and OUT.
• Be careful when connecting the SAS cable. The tip of the SAS cable may be
inserted into a gap between the SAS port and the chassis and damaged.
• Check that optional cable latch clicks and the cables are surely connected.
Figure 9-33 Note on Connecting the SAS Cable
SAS cable
Tip of the SAS cable
Gap
between the SAS port and the chassis
UBX (Rear view)
DKC (Rear view)
SBX/FBX (Rear view)
Tip of the SAS cable
Gap
between the SAS port and the chassis
SAS cable
: SAS port
To Next Page
Loading...
