Hitachi DKC910I - Installing ENC; Installing ENC for SBX;UBX;FBX;NBX

Copyright © 2019, 2021, Hitachi, Ltd.
DKC910IHitachi Proprietary
[INST(IN)08-03-10]
Rev.1
INST(IN)08-03-10
8.3 Installing ENC
8.3.1 Installing ENC for SBX/UBX/FBX/NBX
NOTICE:
• Do not touch the ENC connector directly because it is breakable.
• Be careful not to hit the connector when inserting the ENC.
ENC
Main edge connector
1. Open the right and left levers of the ENC to be installed toward you, and open them completely.
2. Install the ENC in the set position.
Insert the ENC until its right and left levers are slightly closed, and then push the levers toward the ENC.
Figure 8-11 Installing ENC
ENC1
Lever
ENC2
Lever