Hitachi PXR

7-48
7.5.7 Printing initiation failure in
ready-for-printing state (no prints)
No prints
Check the print
target detector
wiring and supply
voltage and enter
the print start
signal to the IJ
printer.
Is the printer in
the “Ready”
state?
Is the encoder
signal properly
entered?
Optimize the print
start delay setting.
Properly enter the
encoder signal.
Connect the cable.
Is the “Profuct
speed matching”
feature is set to
“Provide Encoder
based” from the IJ
printer screen?
Resume the
operation.
Replace the EZJ93
board.
Is the high-
voltage cable
disconnected?
Replace the EZJ95
board.
Y
es
Y
es
Does the obtained
print consist of
spaces only?
No
No
No
Is the cable
between the
EZJ93 board
CN7 connector
and EZJ95 board
CN1 connector
disconnected?
Y
es
No
Place the printer in
The “Ready” state.
No
Y
es
Y
es
No
Y
es
No
Is the print
start delay
setting
p
ro
p
er?
Are prints made?
No
Y
es
Are prints made?
No
Y
es
Are prints made?
No
Y
es
Y
es
No
Are prints made?
Y
es
Enter characters
other than a
space.
No
Are prints made?
Is the print start
signal entered?
Connect the cable.
Y
es
Y
es
No
Y
es
No
Are prints made?