Hitachi PXR User Manual

2-30
 2.11 Handling of the warning “Product Speed Matching Error”
- The warning “Product Speed Matching Error” can be set to “Enable” or “Disable”.
Enable: The warning message is displayed when the conditions are met.
Disable: The warning is not displayed even is the conditions are met.
- The screen for the setting is displayed at the “Service personnel maintenance mode”, and
it is not displayed at the “User maintenance mode”.
1 Put it into the Service personnel maintenance mode by using
Password protection.
2 Press User environment setup at the Environment setup menu.
3 Change the setting value of the “Product speed matching error”.
* Caution:
Even if a condition for the warning happens and the print disordered, the warning will
not be displayed when the value is set to “disable”.




Back
Status:XXXXXXXX
X
2011.07.07 12:45Use
r
en
v
ironmen
t
setup
0 9 8 7 6 5 4 3 2 1
Decre-
ment
Incre-
ment
Shut
down
Start
up
Comm
On/Off
Show
cursor
Manual
Apply
Repeat print sensor mode
[ 1 ] (1:signal ON 2:OFF-ON transition)
Reverse direction printing
[ 0 ] (0:Disable
1:OFF=ABC 2:OFF=CBA )
Reverse prin
t
[ 1 ] (1:method1 2:method2)
Speed compensation
[ 0 ] (0:Disable 1:Enable)
Print signal type
[ 1 ] (1:print. complete 2:print.-in-progress)
Method to apply print data
[ 1 ] (1:method1 2:method2)
Char. Size menu 1 [ 1 ] (1:5x8 2:5x7)
Char. Size menu 2 [ 1 ] (1:7x10 2:9x8 3:9x7)
Excitation V-ref. warning [ 1 ] (0:Disable 1:Enable)
Product speed matching erro
r
[ 1 ] (0:Disable 1:Enable)

Hitachi PXR Specifications

General

Brand	Hitachi
Model	PXR
Category	Printer
Language	English