Hitachi PXR

2-36


5 Change the option to set up to “1: Enable”.

























6 Press OK.
“Wait for a minute” is displayed. After the completion of the setup, the screen returns
to the service maintenance screen.



7 After the completion of setup, press the ejector (button) and take the
memory card out of the slot.
8 Check the function of the software option.



Decre-
ment
↓
Incre-
ment
↑
Cancel

OK
Status:XXXXXXXXX 2011.07.07 12:45Option Setup
02-1 Addition of printing columns
03- 1Addition of registers
04- 1Special communication A
05-1 External signal A
08-1 Barcode reader connection
16-3 Communication buffer
[ 0 ] (0: Disable 1: Enable )
[ 0 ] (0: Disable 1: Enable )
[ 0 ] (0: Disable 1: Enable )
[ 0 ] (0: Disable 1: Enable )
[ 0 ] (0: Disable 1: Enable )
[ 1 ] (0: Disable 1: Enable )