Hitachi RAS-(4-12)HNP(1)(E) - System Control; Individual Operation

4 Electrical wiring
116
SMGB0087 rev.0 - 12/2013
4.6 SystemControl
4.6.1 Individual Operation
1 2
ON
OFF
DSW6
Control wiring (H-LINK II)
DIP switch 6 setting is NOT required.
(The factory setting position is for the
individual operation.)
Outdoor unit
Indoor unit
Remote control switch (PC-ART)
IndividualThermoON/OFFOperation
The individual Thermo ON/OFF is available to be controlled each indoor unit even if multiple indoor units are controlled
simultaneously by one remote control switch.
1 2
ON
OFF
DSW6
Control wiring (H-LINK II)
Transition wiring
The transition wiring is required when
operate multiple indoor units by one (1)
remote control switch.
Outdoor unit
Indoor unit
Remote control switch (PC-ARF)
ControlMethod byeachOptionalRemoteControlSwitch
OperationMethod byOneGroup
(1) ON/OFF Yes
(2) Setting of Operation Mode Yes *1)
(3) Room Temperature Setting Yes
(4) Fan Speed Setting Yes
(5) Timer Setting Yes
(6) ON/OFF by Timer Control Yes
(7) Operation Indication Yes
(8) Alarm Indication Yes
(9) Self-Checking Yes
(10) Test Mode Yes
(11) Individual Louver Setting Yes *2)
(12) Motion Sensor Setting Yes *3)
 N O T E
• Yes:Available
• *1)Coolingandheatingcannotbeoperatedsimultaneously.
• *2)OnlyforRCI-FSN3serieswithPC-ARF
• *3)OnlyforRCI-FSN3+P-AP160NAE+PC-ARF
• Donotmixotherindoorunit,airpanel(P-AP160NA1)andremotecontrolswitch(PC-ARF)
• ifsetfromoneremotecontrolswitch.