Hitachi RAS-(4-12)HNP(1)(E)

To Next Page

To Previous Page

10 Servicing

384

SMGB0087 rev.0 - 12/2013

10.5 RAS-(8-10)HNPE

10.5.1 Removing service cover

N O T E

• Follow the procedure below to remove main parts and components. For mounting follow the reverse procedure of

removal.

• Donotexposetherefrigerantcycletotheatmosphereforalongperiodtoavoidmoistureordustenteringintothecycle.

Besuretoreplacepartsimmediatelyafterremoving.Sealtherefrigerantcyclewhenleftunattachedforalongperiod.

1 Remove the 4 xing screws, slide the service cover downward and

remove it.

• Pay attention not to fall off the service cover.

Service Cover

Service

cover

10.5.2 Removing air outlet grille

1 Remove the 8 xing screws of the shroud.

Air Outlet Grille

Shroud

Air outlet grille

Shroud

Air outlet grille

Hitachi RAS-(4-12)HNP(1)(E) - Page 398