Hitachi RAS-(4-12)HNP(1)(E) - Page 440

10 Servicing
426
SMGB0087 rev.0 - 12/2013
10.8 RAS-(8-10)HNCE
10.8.1 Removing service cover
N O T E
• Followtheprocedurebelowtoremovemainpartsandcomponents.
Formountingfollowthereverseprocedureofremoval.
• Do not expose the refrigerant cycle to the atmosphere for a long
period to avoid moisture or dust entering into the cycle. Be sure to
replace parts immediately after removing. Seal the refrigerant cycle
when left unattached for a long period.
1 Remove the 4 xing screws, slide the service cover downward and
remove it.
• Pay attention not to fall off the service cover.
Service Cover
Service
cover
10.8.2 Removing air outlet grille
1 Remove the 8 xing screws of the shroud.
Air Outlet Grille
Air Outlet Grille
Shroud
Air outlet grille
Shroud
Air outlet grille