Hitachi RAS-(4-12)HNP(1)(E) - Page 55

2 Unit Installation
41
SMGB0087 rev.0 - 12/2013
2
Attaching example of snow protection hood
1. Fixing screw (Accessories).
2. Rear suction hood
3. Wire rope (Optional. For overturning protection)
4. Air discharge grille
5. Left suction hood
6. Air discharge hood
A. Left side
B. Front side
C. Rear side
Specicationsofsnowprotectionhood
Productname Airdischargehood Rearsuctionhood Leftsuctionhood
Model ASG-NP335F ASG-NP335FS2 ASG-NP80B ASG-NP160BS2 ASG-NP80L ASG-NP160LS2
Quantity 2 per unit 1 per unit
Material
Bonderized
steel sheet
Iron
Stainless
(NSSC 180)
Bonderized
steel sheet
Iron
Stainless
(NSSC 180)
Bonderized
steel sheet
Iron
Stainless
(NSSC 180)
Color
Gray
(1.0Y8.5/0.5 or
approximation)
—
Gray
(1.0Y8.5/0.5 or
approximation)
—
Gray
(1.0Y8.5/0.5 or
approximation)
—
Weight 3 kg 14 kg 8 kg
Assembling Knockingdown parts (assembled at eld)
Components
Hood For air discharge part x 1
For rear side air intake x 1
(Upper side x 1 lowe side x 1)
For left side air intake x 1
Unit Fixing
screw
4 (M5x12 tapping screw) 5 (M5x14 tapping screw) 6 (M5x12 tapping screw)
Unit Fixing
screw (SUS)
6 (M5x12
tapping screw)
6 (M5x14)
12 (M5x12
tapping screw)
12 (M5x14)
10 (M5x12
tapping screw)
10 (M5x14)
Installation manual
Installation restriction
Installation with “Guard net” or
“Wind guard” is not available
Installation with “Guard net” is not available
Safety wire rope for over-
turning prevention
(optional parts)
ASG-SW20A