Hitachi VM-E530A - Attaching the Shoulder Strap; Using the Linear Time Counter; Remaining Tape

Attaching the Shoulder Strap
Thread the ends of the provided shoulder strap through the slots at the back of the camcorder and thread
through the shoulder straps' buckles.
Note:: Make sure that the straps are securely fastened before using the shoulder strap to carry the
camcorder.
Using the Linear Time Counter
The linear time counter displays the tape run in
hours, minutes , and seconds, helping you to keep
track of how long you've been filming or time you
have left to film before running out of tape.
Turn the camcorder on to display the linear time
counter. The linear time counter keeps track from
when you load a cassette into the camcorder and
clears to "0:00:00" when the cassette is ejected.
Remaining Tape
The tape remaining display shows the remaining
tape that can be used for recording and play¬
back, using seven dashes. This feature is handy
when recording since if lets you know how long
you can record on the loaded tape.
Insert a cassette into the camcorder and start
recording or playback; 10 seconds later, the
remaining tape will be displayed. When the cas¬
sette is ejected, the display will disappear.
" HU-" is displayed for 10 seconds after
the tape starts to run.
Mote: The tape remaining display appears 10
seconds after the tape starts to run.
Mote: When the remaining tape time
becomes less than about three minutes,
“TAPE END" flashes in the viewfinder.
0 : 0 0 : 10
IsaCZCZD
VM-E530A
E19