Hitachi VM-E530A - Correcting Errors; Recording Title on a Tape in the Camcorder; Recording a Created Title While Transferring a Tape

Correcting Errors
1. P ress the TITLE ON/OFF button on the remote
control.
2... Use the STOP button to select the character to
be corrected.
3. Use the F.FW’D and REW buttons to correct the
character.
4. Press the TITLE ON/OFF button on the remote
control to store the corrected title in memory.
Recording Title on a Tape in the Camcorder
1. Hold down the red button on the CAM/
OFF/VIDEO switch while sliding the switch to
CAM.
2. Locate the point of the tape where you wish to
record the title ("Using Quick Edit/' p36).
3. Press the TITLE ON/OFF button on the remote
control
4. Press the Start/Stop button to start recording
the title.
5. Press the TITLE ON /OFF button on the remote
control to stop recording the title. The title
graphics disappear from the viewfinder and the
camcorder can record normally.
Mote: Create and store your title before an
event you plan to record. Just press the TITLE
ON/OFF button on the remote control to
superimpose the title over the scene as you
record it. This method avoids erasing pre¬
viously recorded material which will happen
when you record a title on a previously record¬
ed tape,
Recording a Created Title while Transferring a Tape
1. Connect the camcorder to the VCR (p27).
2. Turn on the VCR and set it to record. Hold
down the red button on the CAM/OFF/
VIDEO switch while sliding the switch to
VIDEO. Press PLAY on the camcorder.
3. Press the TITLE ON/OFF button on the remote
control at the point on the tape where you wish
to record the title.
4. P ress the TITLE ON/OFF button on the remote
control again to stop recording the title.
Mote: Recording the title during tape transfer
will erase a portion of your recorded material.
E40
HITACHI