Hitachi VSP Gx00 series

4. Br
owse to the certicate le and click Open. The File Upload window closes and
returns you to the Update Certicate Files dialog box.
5. In the Web Server Password: eld, enter the certicate password.
6. Enter the password again in the Web Server Re-enter Password: eld.
7. Select a Connect to SVP certicate le to update. Click the Connect to SVP
checkbox, then click Browse.
8. Browse to the certicate le and click Open. The File Upload window closes and
returns you to the Update Certicate Files dialog box.
9. In the Connect to SVP Password: eld, enter the certicate password.
10. Enter the password again in the Connect to SVP Re-enter Password: eld.
11. Click Apply to update the certicates.
Releasing HTTP communication blocking
If the web server supports SSL (HT
TPS), you can use the HTTP setting tool to release a
block to the HTTP communication port as needed.
Before you begin
■
You must have the Storage Administrator (Initial Conguration) role to perform this
task.
■
Y
ou must be logged into the SVP.
Procedure
1. Close all Device Manager - Storage Navigator sessions on the SVP.
2. Open a command prompt window with administrator permissions.
3. In the folder where the HTTP setting tool is located, execute the following
command:
C:\MAPP\wk\Supervisor\MappIniSet>MappHttpRelease.bat
4. A completion message box displays. Press any key to acknowledge the message and
close the message box.
Releasing HTTP communication blocking
Chapter 5: Setting up security
System Administrator Guide for VSP Gx00 models and VSP Fx00 models 155