Hitachi VSP Gx00 series User Manual

3. In the folder wher
e the .bat le is located, execute the following command:
C:\MAPP\wk\Supervisor\MappIniSet>MappSetPortInit.bat
4. An initialization conrmation message box displays.
If you want to continue, enter Y, and then pr
ess the Enter key. If you want to cancel
the task, enter N, and then press the Enter key.
5. A service restart message box displays, followed by a completion message box.
Press any key to acknowledge the message and close the message box.
6. Close the Windows command prompt.
Reassigning an automatically assigned port number
You can reassign the port number that is automatically assigned to the storage system.
If the port number assigned to the storage system is used in another application, the
port number is reassigned. Also, if you disabled the automatic assign, this deletes the
unnecessary port number that is already assigned.
Caution:
■
Stop the stor
age system service before reassigning. If you did not stop
before reassigning, stop the storage system service in Storage Device List
window, then start the service.
■
The port for DeviceJettyStart and DeviceJettyStop that is assigned when
starting the storage system service cannot be reassigned.
■
If you disable the function which is using the port, this deletes the port
number that is already assigned.
Procedure
1. Logout from Device Manager - Storage Navigator on the storage system that you
want to reassign.
2. Stop the service of the storage system that you want to reassign.
3. Open the Windows command prompt as administrator on the SVP.
4. In the folder where the .bat le is located, execute the following command:
C:\MAPP\wk\Supervisor\MappIniSet>MappPortManageRenum.bat serial-
number (optional)
Note: A space is r
equired between MappPortManageRenum.bat and
serial-number.
If you omitted the serial number, it is executed for the storage system of 83-03-01-
XX/00 or later that is r
egistered in the Storage Device List window.
5. A conrmation message box displays.
If you want to continue, enter Y, and then press the Enter key. If you want to cancel
the task, enter N, and then press the Enter key.
6. Press any key to acknowledge the message and close the message box.
7. Close the Windows command prompt.
8. Start the service of the storage system which is reassigned.
Reassigning an automatically assigned port number
Chapter 3: Conguring the storage system
System Administrator Guide for VSP Gx00 models and VSP Fx00 models 61

Hitachi VSP Gx00 series Specifications

General

Brand	Hitachi
Model	VSP Gx00 series
Category	Storage
Language	English