Hitachi VSP Gx00 series User Manual

Procedure
1. Open the Windo
ws command prompt as administrator on the SVP.
2. In the folder where the .bat le is located, execute the following command:
C:\MAPP\wk\Supervisor\MappIniSet>MappPortRangeSet.bat port-number-
key-name port-number-range
Note:
■ A space is r
equired between MappPortRangeSet.bat and port-
number-key-name.
■ A space is required between port-number-key-name and port-number-
range.
The following table shows the port number key name and initial value of the port
number range which can be changed. Port 0 is not assigned.
Port number key name Initial value of port
number range
Remark
PreRMIServer 51100 to 51355 None
SMIS_CIMOM 5989 to 6244 None
DeviceJettyStart 48081 to 48336 None
DeviceJettyStop 48411 to 48666 None
unavailable 1 to 1023 Port number that is not
used in automatic assign
■ The valid r
ange of the port number is between 1 and 65535. Use a port number
that is not used in another service.
■ Port numbers between 1 and 1023 are reserved for the other applications. If you
exclude a number between 1 and 1023 from the setting value of unavailable, the
port numbers might not operate normally.
■ The following can be used for the port number range:
Numbers, space, symbols (, -) and rm
■ You can specify multiple port-number-key-name and port-number-range.
For example: MappPortRangeSet.bat PreRMIServer 51200-55000
SMIS_CIMOM 5989-6244,8000
3. Press any key to acknowledge the message and close the message box.
4. Close the Windows command prompt.
Initializing the range of an automatically assigned port number
You can initialize the range of the port number that is automatically assigned to the
storage system.
Initializing the range of an automatically assigned port number
Chapter 3: Conguring the storage system
System Administrator Guide for VSP Gx00 models and VSP Fx00 models 63

Hitachi VSP Gx00 series Specifications

General

Brand	Hitachi
Model	VSP Gx00 series
Category	Storage
Language	English