Hitachi VSP Gx00 series

2. Select the type of tr
ansfer protocol to use.
3. In Primary Server:
a. Click Enable to use the server or Disable not to use it.
b. Select the type of IP address to use for the server: IPv4 or IPv6.
c. In Client Certicate File Name, click Browse to select a client certicate le.
4. In Secondary Server:
a. Click Enable to use the server or Disable not to use it.
b. Select the type of IP address to use for the server: IPv4 or IPv6.
c. In Client Certicate File Name, click Browse to select a client certicate le.
5. In Location Identication Name, enter a name to use to identify the server.
6. To set up an automatic attempt to reconnect to the server in case of communication
failure, in Retry, click Enable. Click Disable to not use this feature.
7. If you enabled retry, in Retry Interval, enter the number of seconds that the
system will wait between retry attempts.
SNMP settings
Procedure
1. Click the SNMP tab.
2. In SNMP Agent, click Enable to use the agent or Disable not to use it.
SNMP settings
Chapter 6: Alert
notications
System Administrator Guide for VSP Gx00 models and VSP Fx00 models 180