DB # 0 1 2 3 4 5
xx 00 01 02 03 04 04
DBxx DB00 DB01 DB02 DB03 DB04 DB05
DBxxy DBPS00y DBPS01y DBPS02y DBPS03y DBPS04y DBPS05y
DB # 42 43 44 45 46 47
xx 42 43 44 45 46 47
DBxx DB42 DB43 DB44 DB45 DB46 DB47
DBxxy DBPS42y DBPS43y DBPS44y DBPS45y DBPS46y DBPS47y
The following table lists the DBPSxxy: y values (wher
e DB# is 0 and xx is 00)
DB# 0
y 1 2
DBPSxxy: y DBPS001 DBPS002
DkuTempMaxInfo.csv
This CSV î ´le contains information about DB temperature for every two hours. A record is
DB temper
ature information obtained from the environment monitor. A record output to
the î ´rst line shows the latest temperature information. Because DB temperature
information is measured by DBPS, items are displayed in this unit*.
DkuTempMaxInfo.csv shows the maximum temperature as DB temperature data. The
total number of items depends on the following model:
â–
VSP G200: 17
â–
VSP G400/VSP G600/VSP F400/VSP F600: 49
â–
VSP G800/VSP F800: 97
The DB temperature data displayed in DkuTempAveInfo.csv (average temperature only),
DkuTempMaxInfo.csv (maximum temperature only), and DkuTempMinInfo.csv (minimum
temperature only) is the same value as the DB temperature data for DkuTempInfo.csv.
If the system is in maintenance mode or the SVP is rebooted, the data that is output
every two hours might not contain data for the period. If a failure occurs in the storage
system, the correct information might not be output.
DkuTempMaxInfo.csv
Appendix A: Examples of storage conî ´guration reports
System Administrator Guide for VSP Gx00 models and VSP Fx00 models 250