Hitachi VSP Gx00 series - Page 64

Procedure
1. Open the Windo
ws command prompt as administrator on the SVP.
2. In the folder where the .bat le is located, execute the following command:
C:\MAPP\wk\Supervisor\MappIniSet>MappPortRangeInit.bat
3. A conrmation message box displays.
■ If you want to continue, enter Y, and then press the Enter key.
■ If you want to cancel the task, enter N, and then press the Enter key.
4. Press any key to acknowledge the message and close the message box.
5. Close the Windows command prompt.
Chapter 3: Conguring the storage system
System Administrator Guide for VSP Gx00 models and VSP Fx00 models 64