67
Elevator to Camber Mixing cont.
18. Scroll to select “FLAP” and press the jog dial to conrm your
selection.
19. Repeat steps 5-15 to congure the ap movements for this
mix. If using only one ap servo, congure only the “FLAP”
row of the value table. If using two ap servos, congure
both rows of the value table.
20. Scroll to the “S/W” eld and press the jog dial twice to
activate the menu.
21. Scroll to select a switch to activate the mix. Press the jog dial
to conrm your selection.
a. If you choose the “NULL” option, the mix will remain active at
all times for this model.
b. If you choose a switch:
- The switch position menu will appear. Scroll to highlight the
switch position that you will use to enable the mix. Press the
jog dial to conrm your selection
You may also select a ight condition in this menu by activating the desired ight condition.
c. If you choose “Cond” (Flight Condition):
-The upper right eld of the menu displays which ight
condition is currently active and will be programmed.
- Scroll to select “ON” and press the jog dial to conrm your
selection. If you toggle the selected switch, the eld in the
top right corner of the screen will indicate when the mix is
active.
- Scroll to the Flight Condition eld and press the jog dial to
activate the menu.
- Choose the desired ight condition and press the jog dial to
conrm your selection.
- Repeat steps 4-18 to dene the settings for each ight condition.
To Next Page
Loading...
Need help?
General
