Hitron CGNM 2250 - Login into the CGNM-2250

INTRODUCTION
Version 1.0, 12/2014. Copyright 2012 Hitron Technologies
22
Version 1.0, 12/2014. Copyright 2014 Hitron Technologies
22
Hitron CGNM-2250 User’s Guide
Take the following steps to manually set up your computer’s IP address to connect to
the CGNM-2250:
NOTE: This example uses Windows XP; the procedure for your operating system
may be different.
1 Click Start, then click Control Panel.
2 In the window that displays, double-click Network Connections.
3 Right-click your network connection (usually Local Area Connection) and click
Properties.
4 In the General tab’s This connection uses the following items list, scroll
down and select Internet Protocol (TCP/IP). Click Properties.
5 You can get an IP address automatically, or specify one manually:
If your CGNM-2250’s DHCP server is active, select Get an IP address
automatically.
If your CGNM-2250’s DHCP server is active, select Use the following IP
address. In the IP address field, enter a value between 192.168.0.2 and
192.168.0.254 (default). In the Subnet mask field, enter 255.255.255.0
(default).
NOTE: If your CGNM-2250 is not using the default IP address, enter an IP address
and subnet mask that places your computer in the same subnet as the
CGNM-2250.
6 Click OK. The Internet Protocol (TCP/IP) window closes. In the Local Area
Connection Properties window, click OK.
Your computer now obtains an IP address from the CGNM-2250, or uses the IP
address that you specified, and can communicate with the CGNM-2250.
1.5 Login into the CGNM-2250
Take the following steps to login into the CGNM-2250’s GUI.