Hitron CGNM 2250 - Adding or Editing a Port Triggering Rule

BASIC
Version 1.0, 12/2014. Copyright 2012 Hitron Technologies
65
Version 1.0, 12/2014. Copyright 2014 Hitron Technologies
65
Hitron CGNM-2250 User’s Guide
4.5.1 Adding or Editing a Port Triggering Rule
To add a new port triggering rule, click Add Rule in the Basic > Port Triggering
screen.
To edit an existing port triggering rule, click Manage in the Basic > Port
Triggering screen.
NOTE: Ensure that Enabled is selected in the Basic > Port Triggering screen in
order to add or edit port triggering rules.
The following screen displays.
Twoway Status Usually a port triggering rule works for two IP
addresses; when a rule is enabled, other IPs will also be
allowed to use the rule as a trigger.
Status Use this field to turn the rule On or Off.
Manage Use this field to Edit a port triggering rule.
Action Use this field to Delete a port triggering rule.
Add Rule Click this to define a new port triggering rule. Port
triggering must first be set to Enabled. See Adding or
Editing a Port Triggering Rule on page 65 for
information on the screen that displays.
Save Changes Click this to save your changes to the fields in this
screen.
Help Click this to see information about the fields in this
screen.
Table 20: The Basic: Port Triggering Screen (continued)