HOEFLON C10 - Page 73

MAINTENANCE/ TROUBLESHOOTING
U.C10.00.00.EN Version 2.0 73
E120
No contact with boom rotation sensor.
Switch machine off and on again.
E121
Incorrect value boom rotation sensor.
Switch machine off and on again.
E122
Incorrect value boom rotation sensor.
Switch machine off and on again.
E123
Not used.
E124
Oil pressure too low Yanmar engine.
Check engine oil level.
E125
Engine temperature too high.
Check coolant level.
E126
Alternator not charging.
Check
alternator.
E127
Not used.
E128
Not used.
E129
Not used.
E130
Not used.
E131
Ballast is crooked.
Slide ballast in and out.
E132
Ballast is crooked.
Slide ballast in and out.
E133
Ballast is crooked.
Slide ballast in and out.
E134
Not used.
E135
Oil pressure winch sensor incorrect.
Contact Hoeflon or your dealer.
E136
No contact with pressure sensor.
Switch machine off and on again.
E137
Incorrect value pressure sensor.
Switch machine off and on again.
E138
Pressure too high.
Unroll
winch cable, reduce lifting weight.
E139
Fault in winch switch.
Winch cable can only be rolled out.
E140
Fault in winch switch.
Winch cable can only be rolled up.
E141
Not used.
E142
Not used.
E143
Not used.
E144
Not used.
E145
Not used.
E146
Not used.
E147
Not used.
E148
No contact with level sensor.
Switch machine off and on again.
E149
Invalid value level sensor.
Switch machine off and on again.
E150
Not used.
E151
Not used.
E142
Maintenance (minor service).
Contact
Hoeflon or your dealer.
E153
Maintenance (major service).
Contact Hoeflon or your dealer.
E154
Maintenance.
Contact Hoeflon or your dealer.