Hologic Trident - How to Add or Edit an Output Group; How to Use the On-Demand Outputs; How to Archive

Trident User Guide
Chapter 4: The User Interface
MAN-02098 Revision 008 Page 27
4.4.2 How to Add or Edit an Output Group
Note
The configuration of Output Groups occurs during
installation, but you can edit existing groups or add new
groups.
To add a new Output Group:
1. Access the Admin screen.
2. Select the Manage Output Groups button.
3. Select the New button, enter the information, then select the output device(s).
4. Select the Add button. When the Update Successful message displays, select OK.
5. You can select any group to set as the default.
To edit an Output Group:
1. Access the Admin screen.
2. Select the Manage Output Groups button.
3. Select the Edit button, then make the changes.
4. Select the Save button. When the Update Successful message displays, select OK.
4.5 How to Use the On-Demand Outputs
The On-Demand Outputs are: Archive, Print, or Export. You can manually Archive, Print,
or Export an image until the procedure is closed.
When you press an On-Demand output button, you have the option to send the image to
any of the configured Outputs.
4.5.1 How to Archive
1. Select the Archive button.
2. Select a storage device:
• Select the List Store Device button and make your selection from the options that
display.
• OR, select the List Output Group button and make your selection from the
options that display.
3. Select the Send button to copy all selected images from the opened case study to the
selected device.
Note
Use the Manage Queue utility in the task bar to review the
archive status.