Honda BF135A - Page 282

BF135A•BF150A
5-129
b. THROTTLE BODY/INTAKE MANIFOLD
REMOVAL
1) Remove the silencer case (P. 5-128).
2) Disconnect the MAP sensor 3P connector and remove the
harness band clip.
3) Remove the water level sensor connector from the the har-
ness clip bracket E.
4) Disconnect the TP sensor 3P connector and remove the
harness band clip from the harness clip bracket E.
5) Remove the throttle rod.
• Do not loosen the pivot lock nut.
6) Remove one 8 x 60 mm flange bolt and remove the throttle
body.
7) Remove the throttle body gasket.
• Replace the throttle body gasket with a new one.
• The intake manifold assembly can be removed by skip-
ping the steps 6 and 7 (i.e. with the throttle body mount-
ed).
8) Disconnect the IAB control valve 2P connector.
[2]
THROTTLE BODY
[1]
THROTTLE
ROD
[1]
MAP SENSOR 3P
CONNECTOR
[2]
HARNESS
BAND CLIP
[2]
WATER LEVEL
SENSOR
CONNECTOR
[3] HARNESS CLIP BRACKET E
[4]
HARNESS
BAND CLIP
[1]
TP SENSOR 3P
CONNECTOR
[1]
IAB CONTROL
VALVE 2P
CONNECTOR