Honda BF135A - Page 575

15-12
b. INSTALLATION
1) Lift up the outboard motor until the 12 x 145 mm stud bolts are flush with the holes in the mount frame of the stern
bracket/swivel case assembly.
2) Holding the outboard motor with the hoist, move the stern bracket/swivel case assembly, that are attached to the
outboard motor stand, slowly toward the outboard motor.
Insert the 12 x 145 mm stud bolts into the mount frame and tighten the two 12 mm self-locking nuts to the specified
torque.
TORQUE: 83 N
.
m (8.5 kgf
.
m, 61 lbf
.
ft)
3) Install the lower rubber mount (P. 14-93).
4) Detach the hoist hooks from the three engine hangers.
[2] HOIST CHAIN
[3]
ENGINE
HANGER (2)
[1] ENGINE
HANGER B
[2] STERN BRACKET/SWIVEL
CASE ASSEMBLY
[1]
12 mm SELF-LOCKING
NUT (2)
83 N
.
m (8.5 kgf
.
m,
61 lbf
.
ft)